MultiCloner V2 - advanced RFID/NFC cloner
Version 2 of the MuliCloner, easier and cheaper than ever. Simply scan the card and clone it to your implant.
The above picture is of the prototype device, which is not available for sale yet, final version should be available in a couple of months. Follow our twitter if you want to be notified when it's released.
The MultiCloner has WiFi and Bluetooth interfaces, simply plug it into your android smartphone or PC, connect to the Bluetooth and open the Proxcloud site in your browser. Scan the card and the MultiCloner will extract the card ID and data contents, even if the card is password protected, the MultiCloner can bypass the password*. Once the MultiCloner has read the card data, place the antenna near the implant and click the clone button.
The MultiClonerV2 supports a far wider range of cards than other available cloners The following cards can be cloned using this device:
- HID prox
- Mifare Classic
- Mifare Ultralight
The MultiCloner comes pre-loaded with Proxcloud firmware, but it can also be used in standalone mode with open source firmware. See the Proxcloud site for more details.
The MultiCloner a specially customized version of the open source Proxmark3 Lite device. The Low Frequency and High Frequency antennas have been tuned for use with implanted chips, make reading writing of implants much easier than readers designed for standard RFID cards.
The primary use of the MultiCloner is simple card cloning to implants, but it is also a general purpose RFID/NFC reader and writer. It can be used with all Cyberise implants for programming and reading data, as well as most chips from other sources.
WiFi and Bluetooth interface
Open source hardware and software
- 1 MultiCloner device. Preloaded with Proxcloud cloning firmware
- 1 Low frequency writable test card
- 1 High frequency writable test card
- 1 USB adapter
Note that you will need the appropriate implant in order to write the coped card.
*The MultiCloner is able to break the encryption on Mifare Classic cards, but not Mifare Ultralight.
The MultiCloner supports a wide range of RFID cards, however some cards cannot be cloned, e.g. the MultiCloner can't copy DESFire, Indala or iClass cards at this time.
The MultiCloner is part of Cyberise.me's MultiPass™ implant system.
- safety: This not an implantable device, and as such has no special safety information.
warranty: This an external reader and so carries a 1 year warranty. If the device fails within 1 year, under normal use, we will replace it.
This an external reader and so carries a 1 year warranty. If the device fails within 1 year, under normal use, we will replace it.
This not an implantable device, and as such has no special safety information.